Remington 870 with scope

[GlennPagano]

I have a Remington 870 rifle with a slip on scope. (http://cdni.llbean.com/is/image/wim/221929_0_41?wid=330&hei=295) When I shoot with the scope sometimes the kickback jams the side of the scope holder and slices open my finger. Does this happen to anyone else?

[condition1]

I use the cantilever barrel, I know its a lot of money, but no issues. That mount looks like it could be painfull.

[ACEarcher]

B-Square mounts are a royal pain in the ace if you don't know what your doing. Take it to a gun shop or a gun smith and have them take a look at it.

[bluecollar$]

I have the same set up and have never had a problem. Which finger is it cutting?

[GlennPagano]

I have the same set up and have never had a problem. Which finger is it cutting?

My trigger finger, but this is only when I do not think about how I am shooting, I just need to move my finger down below the scope mount.

[H&R slugger]

My trigger finger, but this is only when I do not think about how I am shooting, I just need to move my finger down below the scope mount.

isnt your trigger finger inside the trigger guard ?:confused:

[GlennPagano]

Yea it is but the back end of my trigger finger hits.

[IMR]

Get a better system. Go Cantilever- no more problems, period. Firmer grip. Hold tight all the way through the whole shot- that means recoil with cheek down. It may help to learn to shoot it with glove on. Look at the guys at Field & Stream, see what they use. All in all, the cantileve is the best solution.

[Pagrizz]

Do you use this gun just for deer hunting deer?If you keep the barrel on all the time and you do not want to spend the money for a new barrel get your 870 drilled and tapped.With the cost of base and rings it will cost less than $100.00 .If you change barrels to hunt other thing it's a pain to keep changing the base on and off then a new barrel is the way to go.I have drilled hundred's over the years and they never have a problem.

[SEMIAUTO]

Go SEMIAUTO and neeeeever L:):)K BACK .